Productos

Arduino 9 axes motion shield

Arduino 9 axes motion shield

Shield Arduino para orientación. Incluye acelerómetro, giróscopo y sensor geomagnético.

COD: A000070

Peso: 0.100 Kg

Disponibilidad: Sin Stock

Su correo electrónico:

ARS 996.00

Cantidad:

El producto no está disponible para la venta en este momento

Características

The Arduino 9 Axes Motion Shield contains the BNO055 absolute orientation sensor from Bosch Sensortec. The BNO055 is a System in Package (SiP) integrating a triaxial 14-bit accelerometer, a triaxial 16-bit gyroscope with a range of ±2000 degrees per second, a triaxial geomagnetic sensor, and a 32-bit microcontroller running the BSX3.0 FusionLib software.

The sensor features three-dimensional acceleration, yaw rate and magnetic field strength data each in three perpendicular axes.

It also provides the sensor fusion signals such as Quaternion, Euler angles, Rotation vector, Linear acceleration, and Gravity vector. In addition, it incorporates an intelligent interrupt engine which allows for triggering interrupts based on slow or no motion recognition, any motion (slope) detection, or high-g detection.

The shield is powered by 5V from your host Arduino, and it consumes 50mW. This shield does not have an external power jack; it is powered only when plugged into an Arduino board. 

I/O Connections

  • 2 TinkerKit connectors for two Analog Inputs (in white), connected to A2 and A3.
  • 2 TinkerKit connectors for two Analog Outputs (in orange in the middle), connected to PWM outputs on pins D5 and D6.
  • 2 TinkerKit connectors for the TWI interface (in white with 4 pins) — one for input and the other one for output, so you can chain devices.

 

 

9 Axes Motion Shield Configuration

The board has two solder jumpers for configuration of the Interrupt Pin and Reset Pin. The Reset Pin comes pre-set to D4 as that is used for all compatible official Arduino boards. However, you will have to make a solder connection on the INT jumper to select the correct Interrupt pin for the Arduino host board you're using. Refer to the table below:

 

BoardINT PinRESET Pin
Arduino Uno D2 D4
Arduino Leonardo D7 D4
Arduino Yun D7 D4
Arduino Ethernet D2 D4
Arduino Due D2 D4
Arduino Mega D2 D4

 

Example Code Available

In the latest Arduino IDE, go to File → Examples and under NAxesMotion you will find four example sketches for using this 9 Axes Motion Shield:

  • Accelerometer — Example code to stream Accelerometer data
  • BareMinimum — Example code to describe the Bare Minimum
  • Euler — Example code to stream Euler data
  • Motion — Example code of a game to demonstrate the Any motion and No motion Interrupt features

Galería de Imágenes

Comentarios

Escribir Comentario

No hay comentarios aún.